Designed and handcrafted with multiple combinations of Duelund tinned copper cables (16GA), carefully fine-tuned to achieve highest sound quality and to minimize signal transmission loss.
Audiolund USB A-B Cable ~ Signature Series
– Use 4*20GA of Duelund tinned copper cables
– USB Type A to Type B
– Use various types and multiple layers of shielding materials for shielding to reduce noise and RFI/EMI interference
– With unique damping design, use various types of anti-vibration/damping materials to suppress vibration and isolation
– 1.0m standard length with other length options
– Option: Standard USB cable or Dual-Headed USB cable
Standard USB version: 1 USB-A and 1 USB-B without separate 5V DC power supply.
Dual-headed USB version: 2 USB-A + 1 USB-B. This design for a separate 5V DC power supply, 1 USB-A plug in to audio source, the other USB-A plug in to 5V DC power supply.
USB can use between 20 AWG to 28 AWG wires. The Signature series USB uses 20AWG wires, reach the spec limit for USB cable. It is OK for audio device application for best sounds, however, it is not recommended to use this Signature series USB cable on other non audio application, it may cause problem.
The USB Cable Signature series, using Duelund tinned copper wire, has similar sound characteristics as the taste of the original Western Electric (WE) sound. Its sound dynamics, with high and low fluctuations are very smooth. Sound density is also very high, with full body, pure and delicate, at the same time sound very musical. The texture is natural with charming music, rich information of premium vinyl/analog sound.
My humble suggestion: Signature Series ~ USB Cable is using all 20GA Duelund cables, it is with Duelund WE typical sound characteristic. Disclaimer: All the Hi-Fi setup different in term of Equipment/Speaker/Room/Accessories etc. so, you may get different results in different setup. The above suggestion is only for your reading reference only.
USB A-B Plugs Orientation
Audiolund cables are quite thick and stiff, although it could be bend easily, but could be hard to “twist” if the orientation of the plugs is not aligned properly. The standard orientation for USB A-B plug is as above, however, it is also depending on how you place your equipment, Top to Down, Left to Right or Right to Left ?
Please provide a picture of your equipment, looking from the back, to show the USB A-B connectors.
Cable Run-In: Audiolund cables are mostly multi-core design with various combinations of wires. Thus, all Audiolund cables will require long time to run-in. OCC Silver wires are thick solid core wires, will take even longer time to burn-in than Duelund tinned copper multi-strands of parallel thin core wires. The general guideline for run-in time, estimated 100 – 200 hours.